This Acrylic Wall Display comes with 2 -Square high quality acrylic plates, predrilled. The Stainless Steel Standoffs are 3/4" diameter x 3/4" high. Eco-Lite Series standoffs are lightweight, sleek, and beautiful. Stainless steel construction, easy to install, brushed stainless finish, Flat Cap- M10 thread, screws included. When mounted to your wall the display will stand out 3/4" from the wall, giving your sign a beautiful contemporary appearance.
Easily change the message inside
To change the print inside, simply remove all the cap knobs by unscrewing them. Be careful as the acrylic sheets will not be held on when the knobs are removed. Place the back acrylic sheet on a table and using a small piece of removable double sided tape on the top back, center up your sign and stick to the back acrylic. Then place the front acrylic sheet over the print and while holding together, screw in the cap knobs into the standoffs on the wall through the acrylic sheets.
Installation of Sign holder
Setting up your sign holder is easy. Center up your sign to make sure its straight. A peice of double sided tape on the inside of the bottom plate should hold on your print without it sliding. Mark and measure your wall (you can use the predrilled holes in the acrylic to mark the wall).
You can use the screws directly into a wood surface, or use the plastic shields for drywall application. For concrete or block you will need to purchase some concrete screws. Once all the standoffs are installed simply attach the acrylic sheets and screw in the knob.