47"x47" Asphalt Decal
- Buy 5 for $181.00 each and save 24%
- Buy 10 for $164.00 each and save 31%
- Buy 25 for $154.00 each and save 35%
- Buy 50 for $147.00 each and save 38%
- Buy 100 for $140.00 each and save 41%
- Buy 500 for $34.90 each and save 85%
- Actual finished size is 47" x 47"
- For use on Asphalt and concrete pavers
- Can handle some vehicle traffic
- Sanded, non slip finish
- Aluminum foil backing allows for the image to flex into surface and hold
- Removable
Upload your file or use the design program below to make you asphalt decals
Asphalt Art® is an anti-slip media that conforms to uneven outdoor surfaces such as asphalt, concrete and paving bricks, providing a painted on effect. Since it withstands vehicle traffic it is great for outdoor advertising, point-of-purchase, events, wayfinding, street art and retail or restaurant pick-up areas.
Installation Instructions-
Asphalt Art® Application Instructions
Issue Date: 6/1/2019 Version 1.2
Surface Preparation
Prior to application of Asphalt Art the surface temperature must be above 50 degrees Fahrenheit. The
surface should be clean, dry and oil-free. Remove any loose debris from the surface. Try to stay 4” or
more from curb gutter area of heavy water flow. Dirty surfaces may require power washing but, the
surface must be dry before application.
Application
1. Snap a line or otherwise mark the perimeter of the application surface.
2. Starting at one corner, remove 6” of liner from the back side.
3. Orient the graphic on the surface; Peel back the liner gradually as you are applying the
graphic. A back and forth, press and smoothing motion is best.
4. Use your fingers, a soft roller or squeegee to work the graphic into any texture or cracks (see
pictures at bottom of page). Pay particular attention to the edges making sure they are securely
adhered to the surface.
5. Using a floor roller, starting at the center and working out covering the entire surface, this
helps to secure the Asphalt Art to the surface.
6. Do NOT overlap the Asphalt Art seams! Asphalt Art should not be applied on top of Asphalt
Art.
7. Repeat process for additional panels if it is a large graphic.
Removal
1. Use a scraper to work up one corner.
2. Grab the raised corner then pull the material back at a 180 degree angle. The material should
pull off in one piece. If the material tears use the scraper to start another edge.
3. Adhesive remover may be needed to remove any remaining adhesive from the surface.
Clean Instructions
Under normal traffic, simply sweeping the Asphalt Art® with a soft broom will remove most loose
particles. When the surface is visibly dirty, cleaning with a soft cloth soap and water will remove
most soils.
Design at designated size plus 1/8" bleed on all sides
RGB and CMYK images are all good.
Images should be 100 to 150 dpi at final size for best print.
Custom cut lines can be made with a vector pantone spot color line in the file. Custom cuts may increase the price, we can tell you once we see the artwork. Note - Vector files must hold in the PDF or EPS file you send us.